• stainless steel

• carbon steel, or

• titanium

depends on the application and the required resistance. Belt material used in the wood processing industry and it’s specification 

Technical data:

Physical and mechanical properties;

Typical values

Every Berndorf Band belt is produced exactly to the customers specification.

During belt production , each belt runs as an endless unit.

This manufacturing process, only,  guarantees perfect tracking and optimal flatness and almost any surface finish can be achieved.
 

• flattening of the material and

• trimming of the belt edges

• longitudinal welding

• again flattening and

• thermal treatment of the material

• again flattening

• grinding

• or other surface treatment on request *

• trimming of both belt edges

• re cutting and milling the belt ends

• final check

• packaging of the Berndorf Band belt.

• mill finished both sides of the belt

• mill finished one side, one side of the belt ground and

• both sides ground

The polished belt surface is required in the photo- and film industry.

( for high gloss belts )

After the required belt surface specification is achieved the belt is cut again and the belt ends are finished, such as :

• open: the belt is precut and delivered with an excess length of about 400 mm, at least. The belt has to be cut to the precise finish length when being installed ( the angle of cut : 90 degrees to the belt edge ) 

• prepared for welding: the belt is delivered in open condition. The belt ends are prepared for welding , the angle of cut is :

for NICRO :  80 degrees to the belt edge.

for CARBO : 80 degrees to the belt edge

for TITAN :   80 degrees to the belt edge

• endless welded: welded at Berndorf, ready to put into the machine